Nokia IP350 - Security Appliance Installation Manual page 77

unsetenv
Use the
the following syntax:
where name is the name of the variable to be cleared.
For example, the following command clears the boot-file variable:
Note
This command sets the autoboot variable to no, and the bootwait
variable to zero.
set-defaults
Use the
values. The command has the following syntax:
where name is the name of the variable to be set to its factory default. If name
is not specified, all variables are set to their factory defaults.
For example, the following command sets the value of autoboot to be yes, the
factory default:
setalias
Use the
syntax:
where name is the alias name, and device the device for which name is the
alias.
Nokia 60s and 100s Installation Guide
command to clear a particular variable. The command has
unsetenv
unsetenv name
BOOTMGR[2]> unsetenv boot-file
command to set variables to their factory-default
set-defaults
set-defaults name
BOOTMGR[2]> set-defaults autoboot
command to set an alias. The command has the following
setalias
setalias name device
Variables
77