Toshiba GR200 Series Instruction Manual page 1211

Line differential protection ied

Hide thumbs Also See for GR200 Series:

Table of Contents

The monitoring function is provided to measure the number of power quantities and statistics

data obtained within the VCT and BI circuits†. When the measuring instruments start

measures power quantities, mathematical means is applied to the data from the VCT so that

the data are shown accurately on the IED screen.

†Note: The VCT/BIO structures and their features are discussed in Chapter

Metering data (Metering group)

Several abbreviations are screened for metering data, which is tabulated below Table

Note: Terms 'I 0 (i.e., 3I 0 )' and 'V 0 (i.e., 3V 0 )' are calculated using three-phase quantities.

Note: The 'I e ' and 'I em ' are obtained usually with corresponding 'I e ' and 'I em ' circuits in

Note: 'CH2' is available when two signaling modules exist in the IED, which is

dependent on the model. Check the ordering number at the C position referring to

the ordering (See

Note: Those metering items are provided for the special models, which are designated at

ordering made.

Note: Positive-sequence V1, which represents power system, is used to measure the

Note: Check the ordering number at the G&T position referring to the ordering (See

Appendix: Ordering)

Appendix: Ordering

6F2S1914 (0.49)

GRL200 (Soft 033 & 037)

Chapters

Table of Contents