Toshiba GR200 Series Instruction Manual page 1387

Line differential protection ied

Hide thumbs Also See for GR200 Series:

Table of Contents

6F2S1914 (0.49)

Edit GOOSE Publish

The signals assigned to GGIO1 variables are published automatically by default.

The GGIO1 data set is fixed and is pre-configured in GOOSE Publish screen. If

the user assign signals to other GGIO variables (for example, GGIO2, GGIO3) for

GOOSE publish operation, then the user needs to add those variables in the

GOOSE Publish screen.

Figure 11.3-20 shows the GOOSE Publish screen, where "System" is fixed and is

not configurable for GGIO1, whereas "Ctrl" (Control) and "Prot" (Protection) are

configurable. The user can add new variables from the "Logical Node" screen to

the GOOSE Publish screen using drag & drop* method. Figure 11.3-20 shows an

example for GOOSE Publish, where "System/GGIO2$Ind1$stVal" is added to the

GOOSE Publish screen.

*Note: Only "stVal" and "q" variables can be added to GOOSE Publish screen.

Figure 11.3-20 GOOSE Publish

GRL200 (Soft 033 & 037)

Chapters

Table of Contents