Toshiba GR200 Series Instruction Manual page 1012

Line differential protection ied

Hide thumbs Also See for GR200 Series:

Table of Contents

switch [GBI-NELD] is provided to set the number of state-changes so that this function will

start to suppress the signal from this point. The user can set [GBI-TELD] pertaining to the

detection period of the repetitive signals (point A to point C). For example, the user can set the

value "10" for the scheme switch [GBI-NELD]; period A–C is set for the setting [GBI-TELD].

The GENBI function should remove event suppressed operation when the repetitive

signals disappear, (that is, the operation of the device is steady); event suppression operation

is cleared when no repetitive signal is found for a set period. The user can set the period using

scheme switch [GBI-TELR]; this reset operation clears the event suppression function at point

E when the last state change is confirmed at point D. Here, the period D–E is set for the Scheme

switch [GBI-TELR].

The event suppression function is provided for every device; the user should set On for

the scheme switch [SLOT1 GBI01-SPPEN], for example.

Table 4.10-2 Example of event list screened

Table 4.10-2 shows the event list screen. This event list is in response to the signals shown

in Figure 4.10-3. Table 4.10-3 lists the common settings for event suppression. Table 4.10-4

shows the settings for a particular slot.

Table 4.10-3 Common settings for event suppression

Scheme switch

Table 4.10-4 Sets for event suppression in each slot

Scheme switch

SLOT1 GBI01-SPPEN

SLOT1 GBI02-SPPEN

Event contents screened

No.10 event suppression SET

Event suppression RESET

Number of Event lock detect time

Timer of detect event lock

Timer of recovery from event lock

SLOT#1 BI-1 Automatic event suppression function

SLOT#1 BI-2 Automatic event suppression function

6F2S1914 (0.49)

GRL200 (Soft 033 & 037)

Chapters

Table of Contents