Validation Of Parameter Or Program; How To Validate Parameter - Mitsubishi Electric MELSEC Q Series Programming Manual

3 START-UP PROCEDURES

3.6 Validation of Parameter or Program

USB/RS-232/
Ethernet
GX Works2/GX Developer

3.6.1 How to validate parameter

The following shows how to transfer safety observation function parameters and user
safety sequence programs created by programming software to CPU modules.
PLC CPU
Safety observation
function parameter
User safety
sequence program
Check the safety parameters transferred from MT Developer2 to Motion CPU on
screen of MT Developer2 or touch panel (GOT etc.) connected to CPU module by
monitoring the parameter information assigned to the Multiple CPU shared device.
Make sure to confirm the parameters by comparing them to parameters written in the
(Note-1)
setting value list
Lock safety parameters by passwords to prevent from changing the setting.
Parameter
transfer
MT Developer2
Verification
Setting value list
(Note-1): List of safety observation function parameter printed by print function of MT Developer2.
Motion CPU
Transfer
Safety observation
function parameter
Consistency
check
User safety
sequence program
.
Motion CPU
Monitor the parameter
information assigned to the
Multiple CPU shared device
on touch panel (GOT etc.).
Verification
(Note-1)
Program designer
3 - 29
USB/
RS-232/
Ethernet
MT Developer2
USB/
RS-232/
Ethernet
GX Works2/GX Developer
Lock by a passwords
to prevent from the
setting change.
Operator