C. Cylinder
D. Piston
NOTE: Steps 1-12 in the preceding sub-section
must precede this procedure.
13. Loosen the clamp securing the coolant hose to the union;
then detach the hose.
14. Remove the two nuts securing the cylinder to the crank-
case.
15. Lift the cylinder off the crankcase taking care not to
allow the piston to drop against the crankcase. Account
for the gasket and two alignment pins.
80
CC022D
To service cylinder, see Servicing Top-Side Compo-
nents sub-section.
When removing the cylinder, be sure to support the pis-
ton to prevent damage to the crankcase and piston.
16. Using an awl, remove one piston-pin circlip.
CC023D
17. Using a suitable piston pin puller, remove the piston
pin. Account for the opposite-side circlip. Remove
the piston.
CC024D
NOTE: It is advisable to remove the opposite-side
circlip prior to using the puller.
AT THIS POINT
CAUTION
CC025D
CC026D
CC032D