Checking/Adjusting Front Wheel Alignment - Toro 500 EFI Service Manual

3. Remove the six screws securing the dash panel to the
frame; then remove the shifter handle and shift lever
boot.
4. Slide the dash panel to the rear sufficiently to access
the components.
5. Remove the nuts securing the gauge assembly to the
dash; then unplug the multi-pin connector and
remove the gauge from the vehicle.
6. Place the new gauge into the dash panel opening;
then place the gauge holder over the mounting
screws and secure with the nuts.
7. Plug the multi-pin connector into the gauge; then
turn the ignition switch to the ON position and check
gauge functions.
8. Slide the dash into position and secure with the six
screws.
9. Install the shifter handle; then install the shift lever
boot.
10. Install the steering wheel boot support.
PR762A
11. Install the steering boot onto the boot support.
12. Install the steering wheel; then with a drop of red
Loctite #271 on the threads of the steering shaft,
install the nut and tighten to 25 ft-lb.
13. Install the lock clip and steering wheel cover.
PR181A
Checking/Adjusting Front
Wheel Alignment

NOTE: All measurements and adjustments must be
made with the vehicle unloaded.
Mark the center-line of the front tires at the front and rear
of the tire; then using a tape measure, measure and record
the distance between the marks at the front and rear. The
front measurement should be 6-12 mm (1/4-1/2 in.)
greater than the rear measurement (toe-out).
PR284A
PR762A
HDX131A
27