Shift Lever - Toro 500 EFI Service Manual


NOTE: There should be an average operating load
on the vehicle when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point
of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the HIGH beam is centered on the vertical
mark 5 cm (2 in.) below the horizontal mark on the
aiming surface.
7. Turn the adjuster nut clockwise to raise the beam and
counterclockwise to lower the beam.

Shift Lever

CHECKING SHIFT CABLE
ADJUSTMENT
1. Turn the ignition switch on; then with the shift lever
in the neutral position, look for the (N) indication on
the LCD. Shift into high range and look for the (H)
indication, low range for the (L) indication, and
reverse for the (R) indication.
14
2. Shift the transmission into park and observe that the
(P) illuminates on the LCD gauge.
ADJUSTING SHIFT CABLE
1. Place the transmission in park; then tilt the cargo
box.
2. Make sure the shift lever is in park; then remove the
E-clip securing the cable end to the shift arm stud.
0740-647
700
500
3. Loosen nuts (A) and (B) and adjust the cable housing
to align the shift cable end to the shift arm stud.
TC004A
4. Install the E-clip; then tighten the nuts (A) and (B) to
8 ft-lb.
5. Check each gear shift position for proper gear selec-
tion and make sure the proper icon illuminates on the
LCD.
HDX251
HDX254
PR568A