Accelerator Pedal; Shift Lever; Shift Cable - Toro 500 EFI Service Manual

Accelerator Pedal

REMOVING
Dislodge the throttle cable holding grommet from the
actuator arm; then remove two torx-head screws and nuts
securing the accelerator pedal assembly to the splash
panel and remove the accelerator pedal.
INSTALLING
Align the mounting holes with the holes in the splash
panel and secure with the two torx-head screws and nuts;
then snap the throttle cable holding grommet into the
actuator arm.

Shift Lever

REMOVING
1. Remove the dashboard (see Dashboard in this sec-
tion).
2. Remove the nut securing the shift cable to the shift
arm; then remove the four cap screws securing the
shift axle supports to the frame and remove the shift
lever.
PR709
INSTALLING
1. Install the shift axle supports onto the shift lever;
then secure the axle supports to the frame with four
cap screws and tighten to 48 in.-lb.
HDX256
2. Secure the shift cable end to the shift arm stud with
the cap screw and nut. Tighten to 8 ft-lb.
REMOVING
1. Remove the dashboard (see Dashboard in this sec-
tion).

Shift Cable

HDX166A
HDX168A
HDX168
25