Right-Side Components; Removing Right-Side Components - Toro 500 EFI Service Manual

Right-Side Components


NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.

NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
D. Oil Pump
1. Remove the cap screws securing the V-belt cover
noting the location of the different-lengthed cap
screws for installing purposes; then using a rubber
mallet, gently tap on the cover tabs to loosen the
cover. Account for two alignment pins and a gasket.
2. Remove and discard the nut securing the movable
drive face; then remove the face. Account for a
spacer.
98
3. Remove the V-belt.
4. Remove the nut securing the fixed driven assembly;
then remove the assembly.
5. Remove the fixed drive face.
6. Remove and discard the cap screws securing the
CF363
windage plate.
CF373A
CF378
PR388