Toro 500 EFI Service Manual page 105

6. Install the clutch cover alignment pins into the crank-
case, apply oil to the cover gasket, and install the
gasket onto the crankcase.
7. Install the one-way clutch onto the clutch shoe
assembly.
CAUTION
When installed correctly, the green alignment dot (or the
word OUTSIDE) on the one-way clutch is visible.
8. Lightly grease the clutch housing seal; then insert the
left fixed-drive spacer.
PR410A
9. Apply grease to the outer edges of the clutch hous-
ing; then from inside the clutch cover, install the
clutch housing into the cover using a rubber mallet.
10. Place the clutch cover/housing assembly into posi-
tion on the crankcase; then secure with the cap
screws making sure the different-lengthed cap
screws are in their proper location. Tighten to 8 ft-lb.
11. Install the windage plate and secure with new
"patch-lock" cap screws. Tighten to 7 ft-lb.
PR399A
12. Place the driven pulley assembly into position and
secure with the nut. Tighten to 162 ft-lb.
CF088A
13. Slide the fixed drive face onto the clutch shaft.
14. Spread the faces of the driven pulley by threading a
cap screw into one of the bosses of the driven fixed
face; then tighten the cap screw until the V-belt drops
into the driven pulley 1/2 to 3/4 inch.
CF085A
CF632A
CF262
103