Toro 500 EFI Service Manual page 63

8. Using an impact screwdriver, remove the three Phil-
lips-head cap screws holding the air intake plate.
Remove the air intake plate.
9. Remove the cap screws holding the clutch cover onto
the right-side crankcase half. Note the positions of
the different-lengthed cap screws for installing pur-
poses.
10. Using a rubber mallet, loosen the clutch cover; then
pull it away from the right-side crankcase half.
Account for two alignment pins and gasket.
D. Centrifugal Clutch Assembly
E. Oil Pump Drive Gear
F. Oil Pump Driven Gear

NOTE: Steps 1-10 in the preceding sub-section
must precede this procedure.
11. Remove the one-way clutch noting the direction of
the green dot or the word OUTSIDE for installing
purposes.
12. Remove the left-hand threaded nut holding the cen-
trifugal clutch assembly.
MD1092
Care must be taken when removing the nut; it has "left-
hand" threads.
MD1115
13. Remove the cam chain.
CAUTION
MD1286
MD1014
MD1016
61