4. Install the outer reverse driven washer; then secure
the reverse driven gear assembly with a snap ring.
5. Install the reverse driven gear dog onto the counter-
shaft and secure with a snap ring.
112
GZ286A
GZ287
6. From the opposite end of the countershaft, install the
high/low driven gear dog (A), thrust washer (B),
bushing (C), bearing (D), high/low driven gear (E),
and spacer washer (F).
GZ288A
7. Install the two drive gear washers and the shift forks.
The countershaft is now ready for installation.
NOTE: When installing the countershaft assembly,
account for the washer on each end of the shaft.
Assembling Crankcase
GZ314
1. Install the secondary drive gear assembly into the
crankcase.
Half
GZ313A
GZ312
GZ283B