Front Bumper Assembly; Hood - Toro 500 EFI Service Manual

To adjust the wheel alignment, use the following proce-
dure.
1. Center the steering wheel; then using an open-end
wrench to hold the tie rod ends, loosen the right-side
and left-side jam nuts.
CAUTION
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.
2. Turn the left-side and right-side tie rods in equal
increments to achieve the proper toe-out; then
tighten the jam nuts securely.
28
PR087A

Front Bumper Assembly

REMOVING
Remove four cap screws and nuts. Account for four lock
washers and eight flat washers.
CLEANING AND INSPECTING
1. Clean all bumper components with hot, soapy water.
2. Inspect all welds for cracking or bending.
INSTALLING
Place the bumper assembly into position on the frame;
then secure with the four cap screws and nuts making
sure the flat washers and lock washers are properly posi-
tioned. Tighten securely.
TC044
REMOVING
1. Open the hood; then disconnect the four headlight
connectors and remove two nylon ties.
PR085A
2. Loosen but do not remove the four cap screws and
flange nuts securing the hood hinge to the frame;
then lower the hood.

Hood

PR086
PR328A