Table of Contents
Advertisement
Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPCA0015J
Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPDM4002I
Device [arg1] VPD is not valid.
FQXSPEA0003J
Link down is detected on port [arg1] of the PCIe device [arg2].
FQXSPEM4040I
Dust filter measurement is completed. The airflow pathway is
obstructed, check and replace the dust filter, or remove any
obstructing object.
FQXSPEM4043I
A [arg1] failure has been detected and need [arg2] to recover.
FQXSPIO4001I
GPU Board Status was changed by [arg1] of [arg1].
FQXSPMA0010J
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName] Throttled.
FQXSPMA4034G
Health of DIMM [arg1] is in warning state and sub-state is [arg2].
FQXSPNM4010I
DHCP[[arg1]] failure, no IP address assigned.
FQXSPNM4032I
DHCPv6 failure, no IP address assigned.
FQXSPPP4009I
The measured power value exceeded the power cap value.
FQXSPPP4010I
The new minimum power cap value exceeded the power cap value.
FQXSPPU0002G
The Processor [ProcessorElementName] is operating in a Degraded
State.
FQXSPPW0006I
[PowerSupplyElementName] has lost input.
FQXSPPW0031J
Numeric sensor [NumericSensorElementName] going low (lower non-
critical) has asserted.
FQXSPPW0057J
Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPPW4002I
Total graphics power value has exceeded the pre-configured limit.
FQXSPSD0002G
Failure Predicted on [StorageVolumeElementName] for array
[ComputerSystemElementName].
FQXSPUN0009G
Sensor [SensorElementName] has asserted.
FQXSPUN0018J
Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPUN0026G
Device [LogicalDeviceElementName] has been added.
FQXSPUN0056G
Sensor [SensorElementName] has asserted.
FQXSPBR4003I
Platform Watchdog Timer expired for [arg1].
FQXSPBR4007I
Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to complete from [arg3] at IP address [arg4].
FQXSPBR4008I
Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to start from [arg3] at IP address [arg4].
FQXSPCA0002M
Numeric sensor [NumericSensorElementName] going low (lower
critical) has asserted.
FQXSPCA0009M
Numeric sensor [NumericSensorElementName] going high (upper
critical) has asserted.
Severity
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Error
Error
Error
Error
Error
.
Chapter 2
XClarity Controller events
23
Advertisement
Table of Contents
