Table of Contents
Advertisement
Complete the following steps:
1. Assert Physical Presence via the Physical Presence Jumper or Remote Physical Presence:
2. NOTE: There are two methods to assert Physical Presence:
a. Move the Physical Presence Jumper to the "ON" position.
b. If the "Physical Presence Policy" has been set to "Enable" in F1 Setup the user is allowed to
assert remote Physical Presence via the IPMI tool. The setting can be found in F1 Setup at
"System Settings -> Security -> Physical Presence Policy Configuration".
3. If TPM version is 2.0, go to next step. If TPM version is 1.2, do the following:
a. From the Setup Utility program main interface, select System Settings -> Security -> Trusted
Platform Module.
b. Change [TPM Device] to "Enable".
c. Change [TPM State] to "Activate".
4. Reboot the system.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0025I: The default system settings have been restored.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU0027N: System uncorrectable error has occurred on Processor [arg1] Core [arg2] MC
bank [arg3] with MC Status [arg4], MC Address [arg5], and MC Misc [arg6].
Severity: Fatal
Parameters:
[arg1]: Socket number, 1-based. [arg2]: CoreNumber [arg3]: McBankNumber [arg4]: McaStatus [arg5]:
McaAddress [arg6]: McaMisc
User Action:
Complete the following steps:
1. Perform a virtual reseat or AC cycle the server.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0030N: A firmware fault has been detected in the UEFI image.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash UEFI image.
3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-
install options one at a time to locate the problem.
4. If problem persists, save customer's UEFI configurations, then remove and re-install CMOS battery
for 30 seconds to clear CMOS contents. If it boots successfully, then restore system settings.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
.
175
Chapter 3
UEFI events
Advertisement
Table of Contents
