Table of Contents
Advertisement
2. Check the Lenovo Support site for an applicable service bulletin or firmware update that applies to
this processor error.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0014N: A processor family mismatch has been detected for one or more processors.
Severity: Error
User Action:
Complete the following steps:
1. Verify that matching processors are installed in the correct processor sockets. Correct any mismatch
found.
2. Check the Lenovo Support site for an applicable service bulletin or firmware update that applies to
this processor error.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0015K: A processor stepping mismatch has been detected for one or more processors.
Severity: Error
User Action:
Complete the following steps:
1. Verify that matching processors are installed in the correct processor sockets. Correct any mismatch
found.
2. Check the Lenovo Support site for an applicable service bulletin or firmware update that applies to
this processor error.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0016N: A processor within the system has failed the BIST.
Severity: Error
User Action:
Complete the following steps:
1. If the processor or firmware was just updated, check the Lenovo Support site for an applicable
service bulletin or firmware update that applies to this processor error.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0017G: A processor microcode update failed.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
processor error.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0018N: CATERR(IERR) has asserted on processor [arg1].
Severity: Error
Parameters:
172
ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference
Advertisement
Table of Contents
