Table of Contents
Advertisement
Understanding the
Lithium-Ion Battery Charger
Refer to
Figure 32
for an overview of the
battery-charger displays and cords.
Figure 32
1. Power-supply cord
Connecting to a Power Source
To reduce the risk of electric shock, this charger has a
3-prong grounded plug (type B). If the plug does not
fit into the wall receptacle, other grounded plug types
are available; contact an authorized Toro distributor.
Do not change the charger or the power-supply-cord
plug in any way.
DANGER
Contact with water while charging the
machine could cause electric shock, causing
injury or death.
• Do not handle the plug or the charger with
wet hands or while standing in water.
• Do not charge the batteries in the rain or in
wet conditions.
Important:
Check the power supply cord
periodically for holes or cracks in the insulation.
g355440
2. Output connector and cord
Do not use a damaged cord. Do not run the cord
through standing water or wet grass.
1.
Insert the charger plug on the power-supply
cord into the matching input power socket on
the charger.
WARNING
A damaged charger cord can cause an
electrical shock or a fire.
Thoroughly inspect the power supply
cord before using the charger. If the cord
is damaged, do not operate the charger
until you obtain a replacement.
2.
Insert the wall plug end of the power supply cord
into a grounded electrical outlet.
Charging the Lithium-Ion Batteries
CAUTION
Attempting to charge the batteries with a
charger not provided by Toro can result in
excessive heat and other related product
malfunctions, which can lead to property
damage and/or injury.
Use the Toro-provided charger to charge the
batteries.
Recommended temperature range for charging:
0° to 45°C (32° to 113°F)
Important:
Charge the batteries only in
temperatures that are within the recommended
range.
Note:
The charger will not function in temperatures
exceeding the minimum or maximum temperatures.
1.
Park the machine in the designated location for
charging.
2.
Engage the parking brake and move the
function-control switch to the N
3.
Ensure that the cutting units are disengaged
and lower them to the ground.
4.
Shut off the machine and remove the key.
5.
Disconnect the power from the machine by
separating the main-power connectors; refer to
Main-Power Connectors (page
6.
Ensure that the connectors are free of dust and
debris.
7.
Raise the connector cover and slide the
charger-output connector into the charger
connector on the machine
38
position.
EUTRAL
23).
(Figure
33).
Advertisement
Table of Contents
