Installing The Roll Bar; Installing The Seat; Installing The Service Decal - Toro 04591 Operator's Manual

1

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar assembly
8 Hex-head bolt (3/8 x 1-1/2 inch)
8 Nut (3/8 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Use 8 hex-head bolts (3/8 x 1-1/2 inch) and
8 nuts (3/8 inch) to secure the roll bar to the
roll-bar brackets on each side of the machine
(Figure 3).
Note:
Have an assistant help you to position
and secure the roll bar to the machine.
Left side of the machine shown
1. Nut (3/8 inch)
2. Roll bar
4. Torque the fasteners to 51 to 65 N∙m (38 to 48
ft-lb).
Figure 3
3. Hex-head bolt (3/8 x 1-1/2
inch)
2

Installing the Seat

Parts needed for this procedure:
Seat Kit (order separately; contact your authorized
1
Toro distributor)
Procedure
Acquire the Seat Kit (contact your authorized Toro
distributor) and refer to the kit Installation Instructions
to install the seat.
3

Installing the Service Decal

Parts needed for this procedure:
1 Service decal (Part Number 137-8052)
Procedure
Install the service decal (Part Number 137-8052) to
the seat; refer to
04729) or Figure 5
04508).
g277676
Premium Seat (Model 04729)
1. Service decal
2. 2.5 cm (1 inch)
12
Figure 4 for the premium seat (Model
for the standard seat (Model
Figure 4
3. 18.5 cm (6.5 inches)
g277096