Toro 04591 Operator's Manual page 39

Note:
The machine connector is located below
the main-power connector that is secured to the
machine.
Figure 33
1. Charger connector
2. Machine connector
8. Connect the charger power cord to a power
source; refer to Connecting to a Power Source
(page 38).
9. Observe the charger to ensure that the batteries
are charging.
Note:
You can connect the main-power
connectors to see the current battery-charge
percentage and amperage in the InfoCenter;
refer to Monitoring the Charging Process and
Troubleshooting (page
The charger will also illuminate with a green light
while the machine is charging.
10. Disconnect the charger when the machine
reaches a sufficient level; refer to
the Charging Process (page
g389188
3. Connector cover
39).
Completing
39).
Monitoring the Charging Process
and Troubleshooting
•
The InfoCenter shows the battery charge
percentage and amperage.
Batteries with a lower voltage charge first; once
they reach the voltage of the other batteries, all
batteries charge simultaneously.
When charging is complete, the machine
InfoCenter displays 10 solid bars.
•
If there is a fault, an error message will appear in
the InfoCenter.
To correct an error, refer to the machine Service
Manual. If none of these solutions correct the
issue, contact an authorized Toro distributor.
Completing the Charging Process
When charging is complete, the battery-charging
indicator light shows solid green and the
charging-output indicator light disappears.
1. Disconnect the charger connector from the
machine connector.
2. Place the charger connector and cord in a
storage position that avoids damage.
3. Ensure that the main-power connectors are
clean.
4. Connect the main-power connectors; refer to
Main-Power Connectors (page
5. Turn on the machine; refer to
Machine (page
6. Verify the charge level; refer to
InfoCenter LCD Display (page
39
Figure 34
23).
Turning On the
30).
Using the
19).
g356360