Toro 04591 Operator's Manual page 18

You can shift from M
OW
to M (not to N
OW EUTRAL
motion; no damage will result
You can move the switch from T
to N and the machine will come to a stop. If
EUTRAL
you try to switch from N
while the pedal is not in the N
advisory occurs.
Lift/Lower Joystick
The lift/lower joystick (Figure
the cutting units. The joystick can engage or
disengage the cutting-unit reels, depending on the
function-control-switch position:
•
Function-control switch in the N
position: The cutting units will raise or lower as
long as you move the joystick forward or backward,
but the reels will not engage unless the machine is
in Backlap Mode.
•
Function-control switch in the M
Move the joystick forward during your cutting
operation to lower the cutting units and start the
reels. Pull back on the joystick to stop the reels
and raise the cutting units.
To stop the reels without raising the cutting units,
pull back on the joystick momentarily and release
it. Moving the joystick forward again will start the
reels or pulling back again will lift the cutting units.
You must engage this feature in the InfoCenter;
refer to Adjusting the Tap-Off Delay (page
•
Function-control switch in the T
position: The cutting units can be raised, but the
reels will not engage. An advisory appears in the
InfoCenter if you attempt to lower the cutting units.
Traction Pedal
The traction pedal (Figure
make the machine move forward, to move it backward,
and to stop the machine. Press the top of the pedal to
move forward; press the bottom to move backward or
to assist in stopping when moving forward.
To stop the machine, allow the pedal to move to the
N position. Do not rest the heel of your foot on
EUTRAL
the traction pedal in the R
machine is moving forward
to T or T
RANSPORT RANSPORT
) while the machine is in
or M
RANSPORT
to M or T
EUTRAL OW RANSPORT
position, an
EUTRAL
14) raises or lowers
EUTRAL
position:
OW
26).
RANSPORT
16) has 3 functions: to
position while the
EVERSE
(Figure 17).
OW
1. Traction pedal—forward
2. Traction pedal—reverse
You can configure the maximum ground speed as
follows:
•
3.2 to 8 km/h (3 to 5 mph) forward mowing speed
•
8 to 16 km/h (5 to 10 mph) transport speed
•
3.2 to 4.8 km/h (2 to 3 mph) reverse speed
Steering-Arm-Locking Pedal
Press the pedal
steering arm for operator comfort, then, release the
pedal to lock the arm in place.
Brake Pedal
Press the brake pedal
18
Figure 16
3. Steering-arm-locking
pedal
Figure 17
(Figure 16) and raise or lower the
(Figure 18) to stop the machine.
g014603
g005105