Adjusting The Transport Speed; Adjusting The Mowing Speed - Toro Greensmaster 3150 Operator's Manual

Adjusting the Transport
Speed
Obtaining the Maximum Transport
Speed
The traction pedal comes adjusted for
maximum-transport speed, but you may need
to adjust it if the pedal reaches full stroke before it
contacts the pedal stop, or if you want to a decrease
the transport speed.
To obtain the maximum-transport speed, put the
functional control lever in the T
press down on the traction pedal. If the pedal contacts
the stop (Figure 47) before you feel tension on the
cable, perform the following adjustment procedure:
Figure 47
1. Pedal stop
1. Put the functional-control lever in the T
position and loosen the locknut securing the
pedal stop to the floor plate
2. Tighten the pedal stop until it does not contact
the traction pedal.
3. Continue applying a light load on the transport
pedal and adjust the pedal stop so it contacts
the pedal rod and tighten the nuts.
Important:
Ensure that the tension on the
cable is not excessive or you will reduce the
cable life.
Reducing the Transport Speed
1. Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
2. Loosen the pedal stop until you obtain the
desired transport speed.
3. Tighten the locknut securing the pedal stop.
position and
RANSPORT
g005520
RANSPORT
(Figure 47).
Adjusting the Mowing
Speed
Factory setting: 6.1 km/h (3.8 mph)
1. Loosen the jam nut on the trunnion bolt on the
side of the traction pedal
1. Trunnion bolt
2. Rotate the trunnion bolt counterclockwise to
increase the mowing speed and clockwise to
decrease it.
3. Tighten the jam nut without turning the trunnion
bolt and check the ground speed. Repeat this
procedure, if required.
38
(Figure 48).
Figure 48
2. Jam nut
g032584