Toro Greensmaster 3150 Operator's Manual page 12

the stud and locks the assemblies together
(Figure 6).
Figure 6
1. Pull frame
2. Pull arm
4. Mount the baskets on the pull frames, loosen
the jam nuts on the pull arms, and adjust the
ball sockets until there is 6 to 13 mm (1/4 to 1/2
inch) clearance between the lip of the basket
and the reel blades.
Note:
This prevents the basket from tipping the
cutting unit forward, causing the lift roller to come
off the lift arm while in the mowing operation.
Note:
Ensure that the basket lip is equidistant
from the reel blades all across each reel. If the
basket is too close to the reel, it is possible for
the reel to contact the basket when the cutting
unit is raised off or lowered to the ground.
5. Align the sockets in the ball joints so the open
side of the socket is centered toward the ball
stud, and tighten the jam nuts to secure the
sockets in position
Figure 7
1. Pull arm
2. Jam nut
6. Ensure that there is approximately 13 mm (1/2
inch) of threads exposed on each reel drive
motor mounting bolt
3. Ball stud
(Figure 7).
3. Ball joint
(Figure 8).
g020794
1. Drive motor
7. Coat the spline shaft of the motor with clean
grease.
8. Install the motor by rotating the motor clockwise
so that the motor flanges clear the studs, then
rotate the motor counterclockwise until the
flanges encircle the studs.
9. Tighten the mounting bolts
g020795
12
Figure 8
2. Mounting bolts
(Figure 8).
g005103