Marking The Outer Grass Baskets; Adding The Rear Ballast And Weight Kit; Installing The Ce Guard Kit - Toro Greensmaster 3150 Operator's Manual

5
Marking the Outer Grass
Baskets
No Parts Required
Procedure
To assist in aligning the machine for successive
cutting passes, do the following procedure to the No.
2 and No. 3 cutting unit baskets:
1. Measure in approximately 12.7 cm (5 inches)
from the outer edge of each basket.
2. Either place a strip of white tape or paint a line
onto each basket paralleling the outer edge of
each basket (Figure
1. Alignment strip
2. Approximately 12.7 cm (5
inches)
9).
Figure 9
3. Cut grass on right
4. Keep focal spot 1.8 to 3
m (6 to 10 ft) ahead of the
machine.
6
Adding the Rear Ballast
and Weight Kit
Parts needed for this procedure:
Rear Weight Kit (Part No. 100-6442)—purchase
1
separately
19.5 kg (43 lb) of calcium chloride (purchase
1
separately)
Rear Weight Kit (Part No. 99-1645)—purchase
1
separately if you have a 3-Wheel Drive Kit installed
Procedure
This machine complies with the ANSI B71.4-2017 and
EN ISO 5395:2013 Standards when you equip it with
the Rear Weight Kit (Part No. 100-6442) and add 19.5
kg (43 lb) of calcium chloride ballast to the rear wheel.
If you install a 3-Wheel Drive Kit, use the Rear Weight
Kit (Part No. 99-1645) instead of Part No. 100-6442.
Important:
If a puncture occurs in a tire with
calcium chloride, remove the machine from the
turf area as quickly as possible. To prevent
possible damage to the turf, immediately soak the
affected area with water.
7

Installing the CE Guard Kit

g005115
Parts needed for this procedure:
1 CE Guard Kit―Part No. 04440 (sold separately)
Procedure
Install the CE guard kit; refer to the CE Guard
Kit―Greensmaster 3150 2-Wheel Drive Traction Unit
Installation Instructions.
13