Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Greensmaster 3150 Operator's Manual

Maintenance

CAUTION
Failure to properly maintain the machine could result in premature failure of machine systems
causing possible harm to you or bystanders.
Keep the machine well maintained and in good working order as indicated in these instructions.
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching
for your machine from the Manuals link on the home page.
Important:
Refer to your engine owner's manual for additional maintenance procedures.
WARNING
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wires from the spark plugs before you do
any maintenance. Set the wires aside so that they do not accidentally contact the spark plugs.

Maintenance Safety

•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage the cutting unit(s).
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first hour
After the first 10 hours
After the first 50 hours
Before each use or daily
Maintenance Procedure
• Torque the wheel nuts.
• Torque the wheel nuts.
• Check the engine speed (at idle and full throttle).
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the safety-interlock system
• Check the safety-interlock system.
• Inspect and cleanup after mowing.
• Check the engine oil.
• Check the tire pressure.
• Check the hydraulic lines and hoses.
• Check the reel-to-bedknife contact.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
27