Installing The Roll Bar; Installing The Cutting Units - Toro Greensmaster 3150 Operator's Manual

3

Installing the Roll Bar

Parts needed for this procedure:
2 Bolt (1/2 x 1-3/4 inches)
6 Bolt (1/2 x 1-1/2 inches)
8 Nut (1/2 inch)
Procedure
1. Remove the screws and nuts supporting the
jack pad on the right side of the machine.
2. Lower the roll bar
brackets, aligning the mounting holes.
1. Jack pad
2. Bolt (1/2 x 1-3/4 inches)
3. Bolt (1/2 x 1-1/2 inches)
3. Secure the left side of the roll bar to the mounting
bracket with 4 bolts (1/2 x 1-1/2 inches) and
locknuts (Figure
4. Torque the fasteners to 91 to 115 N∙m (67 to 85
ft-lb).
5. Secure the right side of the roll bar and the
previously removed jack pad to the mounting
bracket with 2 bolts (1/2 x 1-1/2 inches), 2 bolts
(1/2 x 1-3/4 inches), and locknuts as illustrated
in Figure 4.
(Figure 4) onto the mounting
Figure 4
4. Roll bar
5. Seat belt
4).
6. Torque the fasteners to 91 to 115 N∙m (67 to 85
ft-lb).
WARNING
Failure to wear the seat belt while operating
the vehicle can result in you being thrown
from the seat and injured during a rollover
accident.
Always use the seat belt.
4

Installing the Cutting Units

Parts needed for this procedure:
3 Cutting unit
3 Grass basket
Procedure
Important:
Do not raise the suspension to the
transport position when the reel motors are in the
holders on the machine frame. Damage to the
motors or hoses could result.
Note:
When sharpening, setting the height of cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
support tubes on the front of the frame and side of the
machine to prevent damaging the hoses.
1. Remove the cutting units from the cartons.
Assemble and adjust them as listed in the cutting
unit Operator's Manual.
2. Slide the cutting unit under the pull frame while
sliding the lift hook onto the lift arm
g213342
1. Lift arm
3. Slide the sleeve back on the ball joint receiver
and hook the receiver onto the cutting unit ball
stud. Release the sleeve so that it slides over
11
(Figure
Figure 5
2. Lift hook
5).
g005101