Table of Contents
Advertisement
To cluster switches
1
AC
2
To data network
switches
Step
Perform on each controller
Cable the cluster interconnect ports to the cluster interconnect
1
switches.
Cable the UTA2 data ports to the data network switches.
2
Cable the management ports to the management network
3
switches.
DO NOT the plug power cords in at this point.
Step 2.
To cable your storage, see
Cabling a switched cluster, Ethernet network configuration
Management network, Ethernet data network, and management ports on the controllers are connected to
switches. The cluster interconnect ports are cabled to the cluster interconnect switches.
Before you begin
See your network administrator for help connecting to the switches.
Step 1.
Cable your system using the following steps:
Note: As you insert the connector, you should feel it click into place; if you do not feel it click,
remove it, turn it around and try again.
To cluster switches
1
AC
To data network
switches
Step
Perform on each controller
Cable the cluster interconnect ports to the cluster interconnect
1
switches.
Cable the UTA2 data ports to the data network switches.
2
AC
"Cabling controllers to drive shelves" on page
AC
2
3
To management
network switches
3
To management
network switches
Chapter 4
Ports used
• e0a
• e0b
• e0c and e0d
• or e0e and e0f
• e0M
Not applicable.
22.
Ports used
• e0a
• e0b
• e0c and e0e
• or e0d and e0f
.
System installation and setup
21
Advertisement
Table of Contents
