Table of Contents
Advertisement
If you want to run diagnostic tests on...
Individual components
Multiple components at the same time
Then...
1. Clear the status logs:
clearstatus
2. Display the available tests for the selected
devices:
sldiag device show -dev dev_name
dev_name can be any one of the ports and
devices identified in the preceding step.
3. Examine the output and, if applicable,
select only the tests that you want to run:
sldiag device modify -dev dev_name
-selection only
-selection only disables all other tests that
you do not want to run for the device.
4. Run the selected tests:
-dev dev_name
After the test is complete, the following
message is displayed:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
5. Verify that no tests failed:
status -dev dev_name -long -state failed
System-level diagnostics returns you to
the prompt if there are no test failures, or
lists the full status of failures resulting from
testing the component.
1. Review the enabled and disabled devices
in the output from the preceding
procedure and determine which ones you
want to run concurrently.
2. List the individual tests for the device:
sldiag device show -dev dev_name
3. Examine the output and, if applicable,
select only the tests that you want to run:
sldiag device modify -dev dev_name
-selection only
-selection only disables all other tests that
you do not want to run for the device.
4. Verify that the tests were modified:
device show
5. Repeat these substeps for each device
that you want to run concurrently.
6. Run diagnostics on all of the devices:
sldiag device run
Attention: Do not add to or modify your
entries after you start running diagnostics.
After the test is complete, the following
message is displayed:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
.
Chapter 5
Hardware replacement procedures
sldiag device
sldiag device run
sldiag device
sldiag
59
Advertisement
Table of Contents
