Completing The Replacement Process - Lenovo ThinkSystem DM3000x Hardware Installation And Maintenance Manual

If the system-level diagnostics tests...
Were completed without any failures
Resulted in some test failures

Completing the replacement process

After you replace the part, you can return the failed part to Lenovo, as described in the RMA instructions
shipped with the kit. Contact technical support at
additional help with the replacement procedure.
Then...
1. Clear the status logs:
clearstatus
2. Verify that the log was cleared:
device status
The following default response is
displayed: SLDIAG: No log messages are
present.
3. Exit Maintenance mode by typing
The controller displays the LOADER
prompt.
4. Boot the controller from the LOADER
prompt:
5. Return the controller to normal operation
by typing:
replacement_node_name
Determine the cause of the problem:
1. Exit Maintenance mode by typing
2. After you issue the command, wait until
the system stops at the LOADER prompt.
3. Verify that you have observed all the
considerations identified for running
system-level diagnostics, that cables are
securely connected, and that hardware
components are properly installed in the
storage system.
4. Fully seat the controller module you are
servicing in the chassis. The controller
module boots up when fully seated.
5. Boot the controller module you are
servicing, interrupting the boot by pressing
when prompted to get to the
Ctrl-C
LOADER prompt.
6. Type
boot_ontap
7. Select Boot to maintenance mode from
the menu.
8. Exit Maintenance mode by entering the
following command:
After you issue the command, wait until
the system stops at the LOADER prompt.
9. Rerun the system-level diagnostic test.
Lenovo Data Center Support
Chapter 5
sldiag device
sldiag
boot_ontap
storage failover giveback -ofnode
menu.
halt
if you need the RMA number or
.
Hardware replacement procedures
halt
halt
43