Table of Contents
Advertisement
If the system-level diagnostics tests...
Were completed without any failures
Resulted in some test failures
Resulted in the same test failures
Then...
There are no hardware problems and your
storage system returns to the prompt.
1. Clear the status logs by entering the
following command:
clearstatus
2. Verify that the log is cleared by entering
the following command:
status
The following default response is
displayed:
SLDIAG: No log messages are present.
3. Exit Maintenance mode by entering the
following command:
4. Enter the following command at the
Loader prompt to boot the storage
system:
boot_ontap
You have completed system-level diagnostics.
Determine the cause of the problem.
1. Exit Maintenance mode by entering the
following command:
2. Perform a clean shutdown and disconnect
the power supplies.
3. Verify that you observed all the
requirements for running system-level
diagnostics, that cables are securely
connected, and that hardware
components are properly installed in the
storage system.
4. Reconnect the power supplies and power
on the storage system.
5. Repeat Steps 1 through 5 of Running slow
system response diagnostics.
Technical support might recommend modifying
the default settings on some of the tests to
help identify the problem.
1. Modify the selection state of a specific
device or type of device on your storage
system by entering the following
command:
sldiag device modify [-dev
devtype|mb|slotslotnum] [-name device]
[-selection enable|disable|default|only]
-selection enable|disable|default|only
allows you to enable, disable, accept the
default selection of a specified device type
or named device, or only enable the
.
Chapter 6
System level diagnostics
sldiag device
sldiag device
halt
halt
107
Advertisement
Table of Contents
