Lenovo ThinkSystem DM3000x Hardware Installation And Maintenance Manual page 106

• mem is system memory.
• nic is a Network Interface Card not connected to a network.
• nvram is nonvolatile RAM.
• nvmem is a hybrid of NVRAM and system memory.
• sas is a Serial Attached SCSI device not connected to a disk shelf.
• serviceproc is the Service Processor.
• storage is an ATA, FC-AL, or SAS interface that has an attached disk shelf.
• toe is a TCP Offload Engine, a type of NIC.
Step 5. Run all the default selected diagnostic tests on your storage system by entering the following
command:
sldiag device run
Step 6. View the status of the test by entering the following command:
Your storage system provides the following output while the tests are still running:
There are still test(s) being processed.
After all the tests are complete, the following response appears by default:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
Step 7. Verify that there are no hardware problems on your new storage system by entering the following
command:
sldiag device status -long -state failed
Example
The following example shows how the full status of the failures is displayed in a test run without the
appropriate hardware:
*> sldiag device status -long -state failed
TEST START ------------------------------------------
DEVTYPE: nvram_ib
NAME: external loopback test
START DATE: Sat Jan 3 23:10:55 GMT 2009
STATUS: Completed
ib3a: could not set loopback mode, test failed
END DATE: Sat Jan 3 23:11:04 GMT 2009
LOOP: 1/1
TEST END --------------------------------------------
TEST START ------------------------------------------
DEVTYPE: fcal
NAME: Fcal Loopback Test
START DATE: Sat Jan 3 23:10:56 GMT 2009
STATUS: Completed
Starting test on Fcal Adapter: 0b
Started gathering adapter info.
Adapter get adapter info OK
Adapter fc_data_link_rate: 1Gib
Adapter name: QLogic 2532
Adapter firmware rev: 4.5.2
Adapter hardware rev: 2
Started adapter get WWN string test.
Adapter get WWN string OK wwn_str: 5:00a:098300:035309
Started adapter interrupt test
Adapter interrupt test OK
Started adapter reset test.
ThinkSystem DM3000x and DM5000x Hardware Installation and Maintenance Guide
100
sldiag device status