Table of Contents
Advertisement
If the system-level diagnostics tests...
Were completed without any failures
Resulted in some test failures
Then...
1. Clear the status logs:
clearstatus
2. Verify that the log was cleared:
device status
The following default response is
displayed: SLDIAG: No log messages are
present.
3. Exit Maintenance mode by typing
The controller displays the LOADER
prompt.
4. If the controller does not automatically
start ONTAP, boot the controller from the
LOADER prompt:
boot_ontap
5. Return the controller to normal operation
by typing:
storage failover giveback -ofnode
replacement_node_name
Determine the cause of the problem:
1. Exit Maintenance mode by typing
2. After you issue the command, wait until
the system stops at the LOADER prompt.
3. Verify that you have observed all the
considerations identified for running
system-level diagnostics, that cables are
securely connected, and that hardware
components are properly installed in the
storage system.
4. Boot the controller module you are
servicing, interrupting the boot by pressing
when prompted to get to the
Ctrl-C
LOADER menu. If you removed the
controller in the previous step, fully seat
the controller module you are servicing in
the chassis. The controller module boots
up when fully seated.
5. Select Boot to maintenance mode by
typing
boot_diags
6. Repeat all the steps necessary to perform
the system level diagnostics for the cache
module.
7. Exit Maintenance mode by entering the
following command:
After you issue the command, wait until
the system stops at the LOADER prompt.
8. Rerun the system-level diagnostic test.
.
Chapter 5
Hardware replacement procedures
sldiag device
sldiag
halt
halt
halt
35
Advertisement
Table of Contents
