Table of Contents
Advertisement
Your storage system provides the following output while the tests are still running:
There are still test(s) being processed.
After all the tests are complete, you receive the following default response:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
Step 5.
Identify the cause of the system panic by entering the following command:
sldiag device status -long
-state failed
Example
The following example shows how the full status of the failures is displayed in a test run without the
appropriate hardware:
*> sldiag device status -long -state failed
TEST START ------------------------------------------
DEVTYPE: nvram_ib
NAME: external loopback test
START DATE: Sat Jan 3 23:10:55 GMT 2009
STATUS: Completed
ib3a: could not set loopback mode, test failed
END DATE: Sat Jan 3 23:11:04 GMT 2009
LOOP: 1/1
TEST END --------------------------------------------
TEST START ------------------------------------------
DEVTYPE: fcal
NAME: Fcal Loopback Test
START DATE: Sat Jan 3 23:10:56 GMT 2009
STATUS: Completed
Starting test on Fcal Adapter: 0b
Started gathering adapter info.
Adapter get adapter info OK
Adapter fc_data_link_rate: 1Gib
Adapter name: QLogic 2532
Adapter firmware rev: 4.5.2
Adapter hardware rev: 2
Started adapter get WWN string test.
Adapter get WWN string OK wwn_str: 5:00a:098300:035309
Started adapter interrupt test
Adapter interrupt test OK
Started adapter reset test.
Adapter reset OK
Started Adapter Get Connection State Test.
Connection State: 5
Loop on FC Adapter 0b is OPEN
Started adapter Retry LIP test
Adapter Retry LIP OK
ERROR: failed to init adaptor port for IOCTL call
ioctl_status.class_type = 0x1
ioctl_status.subclass = 0x3
ioctl_status.info = 0x0
Started INTERNAL LOOPBACK:
INTERNAL LOOPBACK
OK
.
Chapter 6
System level diagnostics
103
Advertisement
Table of Contents
