Table of Contents
Advertisement
Recabling the system
After running diagnostics, you must recable the controller module's storage and network connections.
Step 1.
Recable the system.
Step 2.
Verify that the cabling is correct.
Reassigning disks
If the storage system is in an HA pair, the system ID of the new controller module is automatically assigned to
the disks when the giveback occurs at the end of the procedure.
About this task
You must use the correct procedure for your configuration:
Controller redundancy
HA pair
Then use this procedure...
"Verifying the system ID change on an HA system" on
page
62.
.
Chapter 5
Hardware replacement procedures
61
Advertisement
Table of Contents
