Table of Contents
Advertisement
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Atzbq4KHJgYQHkA9FCH0-m
Step 1.
If you are not already grounded, properly ground yourself.
Step 2.
If you have not already done so, replace the cover on the controller module.
Step 3.
Align the end of the controller module with the opening in the chassis, and then gently push the
controller module halfway into the system.
Note: Do not completely insert the controller module in the chassis until instructed to do so.
Step 4.
Cable the management and console ports so that you can access the system to perform the tasks
in the following sections.
Step 5.
Complete the reinstallation of the controller module:
If your system is in...
An HA pair
Restoring and verifying the system configuration
After completing the hardware replacement and booting to Maintenance mode, you verify the low-level
system configuration of the replacement controller and reconfigure system settings as necessary.
ThinkSystem DM3000x and DM5000x Hardware Installation and Maintenance Guide
56
Then perform these steps...
The controller module begins to boot as soon
as it is fully seated in the chassis. Be prepared
to interrupt the boot process.
1. With the cam handle in the open position,
firmly push the controller module in until it
meets the midplane and is fully seated,
and then close the cam handle to the
locked position.
Attention: Do not use excessive force
when sliding the controller module into the
chassis; you might damage the
connectors.
The controller begins to boot as soon as it
is seated in the chassis.
2. If you have not already done so, reinstall
the cable management device.
3. Bind the cables to the cable management
device with the hook and loop strap.
4. Press
when you see the message
Ctrl-C
Press Ctrl-C for Boot Menu.
5. From the Loader prompt type:
menu
6. Select the option to boot to Maintenance
mode from the displayed menu.
boot_ontap
Advertisement
Table of Contents
