Cab Maintenance; Cleaning The Cab Air Filters; Cleaning The Air Conditioning Coil - Toro 30607A Operator's Manual

Cab Maintenance

Cleaning the Cab Air Filters

Service Interval: Every 250 hours (Replace them if
they are torn or excessively dirty.)
1. Remove the thumb screws and grates from over
both the in-cab and rear cab air filters
113).
Figure 113
1. Thumb screw
2. Grate
2. Clean the filters by blowing clean, oil free,
compressed air through them.
Important:
If either filter has a hole, tear, or
other damage, replace it.
3. Install the filters and grate, securing them with
the thumb screws.
(Figure
g009265
g009266
3. Air filter
Cleaning the Air
Conditioning Coil
Service Interval: Every 250 hours (Clean more
frequently in extremely dusty or dirty
conditions)
1. Stop the engine and remove the key.
2. Remove the (4) screws securing the fan and the
condenser cover to the fan mount
3. Carefully lift the fan out of the condenser cover.
1. Cabin roof
2. Condenser cover
3. Washer
4. Nut
4. Remove the two nuts and washers securing
the front of the condenser cover to the cab roof
(Figure 114).
5. Unplug the fan wire connectors located between
the cover and roof.
6. Remove the fan and the cover.
7. Remove and clean the A/C Condenser Screen.
Refer to Cleaning the A/C Condenser Screen.
8. Clean the air conditioning condenser thoroughly
with compressed air
9. Replace the A/C Condenser Screen.
10. Replace the condenser cover and fan. Make
sure to connect the fan wires before securing
the condenser cover.
72
(Figure
Figure 114
5. Fan
6. Screw
7. Air conditioning condenser
(Figure 114).
114).
g011842