Lubrication; Greasing The Bearings And Bushings - Toro 30607A Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be
lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated
under normal conditions, lubricate all bearings
and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2)
•
Front and rear axle pivot bushings (2)
•
Steering cylinder ball joints (2)
•
Tie rod ball joints (2)
•
King pin bushings (2)
The top fitting on the king pin should
only be lubricated annually (2 pumps).
Figure 59
Figure 60
(Figure
(Figure
(Figure 61)
(Figure 61)
(Figure 61).
59)
60)
Front Cutting Unit
•
Castor fork shaft bushings (2)
•
Spindle shaft bearings (3) (located under the
pulley) (Figure
•
Idler arm pivot bushings (2)
g009246
g004687
50
Figure 61
(Figure
63)
(Figure 63)
Figure 62
g011499
62)
g011557