Toro 30607A Operator's Manual page 19

Engine Speed Switch
The engine speed switch
to change the engine speed. By momentarily tapping
the switch, the engine speed can be increased or
decreased in 100 rpm increments. By holding the
switch down the engine will automatically move to
High or Low idle, depending on which of the switch is
depressed.
PTO Switch
The PTO switch (Figure
(start) and In (stop). Pull the PTO button out to
engage the cutting unit blades. Push in the button to
disengage the cutting unit blades.
Hi-Lo Speed Control
The switch (Figure 4) allows the speed range to
increase for transport of the machine. Cutting decks
will not operate in high range. To switch between the
High and Lo range, the decks must be raised, PTO
disengaged, cruise control disengaged, traction pedal
in neutral position and the machine must be moving at
a slow speed.
Lift Switches
The lift switches (Figure
units. Press the switches forward to lower the cutting
units and backward to raise the cutting units. When
starting the machine, with the cutting units in the down
position, press the lift switch down to allow the cutting
units to float and mow.
Note:
The decks will not lower while in the HI speed
range and they will not raise or lower if the operator is
out of the seat when the engine is running. Also, the
decks will lower with the key in the On position and
the operator in the seat.
Cruise Control Switch
The cruise control switch
pedal position to maintain the desired ground speed.
Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the
cruise control function and the front of the switch sets
the desired ground speed.
Note:
Pressing either brake pedal or moving the
traction pedal into the reverse position, for one
second, will also disengage the pedal position.
(Figure 4) has two modes
4) has two positions: Out
4) raise and lower the cutting
(Figure 4) locks in the
Power Point
The power point (Figure
electrical accessories.
1. Power point
Seat Adjustments
Fore and Aft Adjusting Lever
Pull out on the lever to slide the seat fore or aft
6).
Seat Arm Rest Adjusting Knob
Rotate the knob to adjust the seat arm rest angle
(Figure 6).
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle
6).
Weight gauge
Indicates when the seat is adjusted to the weight of
the operator (Figure
by positioning the suspension within the range of the
green region.
19
5) is used to power optional
Figure 5
6). Height adjustment is made
g020443
(Figure
(Figure