Table of Contents
Advertisement
Drive System
Maintenance
Adjusting the Traction
Pedal Angle
The traction pedal operating angle can be adjusted
for operator comfort.
1.
Loosen the two nuts and bolts securing the left
side of the traction pedal to the bracket
88).
Figure 88
1. Traction pedal
2.
Pivot the pedal to the desired operating angle
and tighten the nuts
Changing the Planetary
Gear Drive Oil
Service Interval: After the first 200 hours
Every 800 hours (Or yearly, whichever comes
first)
Change the oil initially after first 200 hours of
operation. Thereafter change the oil every 800 hours,
or yearly, whichever occurs first. Use a high quality
SAE 85W-140 gear lube.
1.
With the machine on a level surface, position a
wheel so that one of the check plugs is at the
lowest (6 o'clock) position
(Figure
2. Mounting nuts and bolts
(2)
(Figure
88)˙.
(Figure
89).
1. Check/drain plug
2.
Place a drain pan under the planetary hub,
remove plug and allow oil to drain.
3.
Place a drain pan under the brake housing,
remove the drain plug and allow the oil to drain
(Figure
90).
g009745
1. Drain plug
4.
When all of the oil has drained from both
locations, re-install the plug in the brake
housing.
5.
Rotate the wheel until the open plug hole in the
planetary is at the twelve o'clock position.
6.
Through the open hole, slowly fill the planetary
with 0.65 liter (22 ounces) of high quality SAE
85W-140 wt. gear lube.
Important:
0.65 liter (22 ounces) of oil is added, wait
one hour or install the plug and move the
machine approximately ten feet to distribute
the oil through the brake system. Then,
remove the plug and add the remaining oil.
7.
Re-install the plug.
8.
Repeat the procedure on the opposite
planetary/brake assembly.
59
Figure 89
Figure 90
2. Brake housing
If the planetary fills before the
g008862
g020680
Advertisement
Table of Contents
