Toro 30607A Operator's Manual page 31

Figure 23
3. Push the castor spindle through the castor arm.
Install the shims (as originally installed) and the
remaining spacers onto the spindle shaft. Install
the tensioning cap to secure the assembly.
4. Remove the hairpin cotter and clevis pins from
the castor pivot arms
5. Rotate tension rod to raise or lower pivot arm
until holes are aligned with selected height-of-cut
bracket holes in the cutting unit frame
24 and Figure 25).
6. Insert the clevis pins and install the hairpin
cotters.
7. Rotate tension rod counterclockwise (finger
tight) to put tension on adjustment.
Figure 24
1. Castor pivot arm
2. Axle mounting holes
decal100-5622nc
(Figure 24).
(Figure
3. Clevis pin and hair pin
cotter
4. Tension rod
8. Remove the hairpin cotters and clevis pins
securing the damper links to the cutting unit
brackets
holes with the selected height-of-cut bracket
holes in the cutting unit frame
the clevis pins, and install the hairpin cotters.
Important:
never be adjusted. The length between
the hole centers should be 13.7 cm (5-3/8
inches).
1. Damper link
g004676
31
Figure 25
(Figure 26). Align the damper link
(Figure
The damper link length should
Figure 26
Figure 27
decal100-5623nc
27), insert
g011549
decal100-5694nc