Table of Contents
Advertisement
Adjusting the Mirrors
Cab model only
Rear View Mirror
While sitting in the seat, adjust the rear view mirror
(Figure
32) to attain the best view out the rear window.
Pull the lever rearward to tilt the mirror to reduce the
brightness and glare of light.
Side View Mirrors
While sitting in the seat, have a helper adjust the side
view mirrors
(Figure
32) to attain the best view around
the side of the machine.
Figure 32
1. Side view mirrors
2. Rear view mirror
Aiming the Headlights
1.
Loosen the mounting nuts and position each
headlight so that it points straight ahead.
Tighten the mounting nut just enough to hold the
headlight in position.
2.
Place a flat piece of sheet metal over the face of
the headlight.
3.
Mount a magnetic protractor onto the plate.
While holding the assembly in place, carefully tilt
the headlight downward 3 degrees, then tighten
the nut.
4.
Repeat the procedure on the other headlight.
Starting and Stopping the
Engine
Important:
The fuel system will automatically
bleed itself when any of the following situations
occur:
•
Initial start up of a new machine.
g008870
3. Lever
•
The engine has ceased running due to lack of fuel.
•
Maintenance has been performed upon the fuel
system components.
1.
Ensure that the parking brake is set. Remove
your foot from the traction pedal and ensure that
it is in neutral.
2.
Turn the ignition key to the Run position.
3.
When the glow indicator dims, turn the ignition
key to the Start position. Release the key
immediately when the engine starts and allow it
to return to the Run position. Allow engine to
warm up at mid speed (without load), then move
the throttle control to the desired position.
Important:
Do not run the starter motor
more than 30 seconds at a time or premature
starter failure may result. If the engine fails
to start after 30 seconds, turn the key to
the Off position, recheck the controls and
procedures, wait 30 additional seconds, and
repeat the starting procedure.
4.
To stop the engine, move the PTO switch to the
Off position, set the parking brake, return the
throttle setting to low idle and rotate the ignition
key to Off. Remove the key from the switch to
prevent accidental starting.
Important:
Allow engine to idle for 5 minutes
before shutting it off after a full load operation.
Failure to do so may lead to turbo-charger trouble.
Smart Power
With Toro Smart Power™, the operator does not have
to listen to the engine speed in heavy conditions.
Smart Power prevents bogging down in heavy turf
by automatically controlling the machine speed and
optimizing cutting performance. The operator can
simply set a max ground speed, that is comfortable,
and mow without having to manually reduce the
traction speed when mowing in heavy conditions.
Reversing Fan Operation
The fan speed is controlled by hydraulic oil
temperature and engine coolant temperature. A
reverse cycle is automatically initiated when either the
engine coolant or hydraulic oil temperature reaches
a certain point. This reversal will help blow debris off
the rear screen and lower the engine and hydraulic
oil temperatures. By simultaneously pressing the
right and left buttons on the InfoCenter, the fan will
complete a manually initiated reverse cycle. It is
recommended to manually reverse the fan prior to
leaving the work area, entering the shop or storage
area.
34
Advertisement
Table of Contents
