Toro 30607A Operator's Manual page 27

Adding Fuel
1. Park the machine on a level surface.
2. Using a clean rag, clean area around fuel tank
cap.
3. Remove cap from the fuel tank
1. Fuel tank cap
4. Fill the tank until the level is to the bottom of the
filler neck with diesel fuel.
5. Install fuel tank cap tightly after filling tank.
Note:
If possible, fill the fuel tank after each
use. This will minimize possible buildup of
condensation inside the fuel tank.
Checking the Hydraulic Fluid
Service Interval: Before each use or daily
The machines reservoir is filled at the factory with
approximately 29 L (7.75 U.S. gallons) of high quality
hydraulic fluid. Check the level of the hydraulic
fluid before the engine is first started and daily
thereafter. The recommended replacement fluid is:
Toro Premium All Season Hydraulic Fluid
(Available in 18.9 L (5 gallon) pails or 208 L (55
gallon) drums. See parts catalog or Toro distributor for
part numbers.)
Alternate fluids: If the Toro fluid is not available, other
fluids may be used provided they meet all the following
material properties and industry specifications. We
do not recommend the use of synthetic fluid. Consult
with your lubricant distributor to identify a satisfactory
product.
Note:
Toro will not assume responsibility for damage
caused by improper substitutions, so use only
products from reputable manufacturers who will stand
behind their recommendation.
(Figure
Figure 13
High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG 46
Material Properties:
Viscosity, ASTM D445
13).
Viscosity Index ASTM D2270
Pour Point, ASTM D97
Industry Specifications:
Note:
Many hydraulic fluids are almost colorless,
making it difficult to spot leaks. A red dye additive for
the hydraulic system oil is available in 20 ml (2/3 oz)
bottles. One bottle is sufficient for 15 to 22 L (4 to 6
US gallons ) of hydraulic oil. Order part no. 44-2500
g020448
from your authorized Toro distributor.
1. Position the machine on a level surface, lower
the cutting units, stop the engine, and remove
the key.
2. Unlatch the seat, raise it, and engage the prop
rod.
3. Clean the area around the filler neck and cap of
the hydraulic tank
from the filler neck.
1. Hydraulic tank cap
4. Remove the dipstick from the filler neck and
wipe it with a clean rag. Insert the dipstick into
the filler neck; then remove it and check the fluid
level. The fluid level should be between the 2
marks on the dipstick.
5. If the level is low, add the appropriate fluid to
raise the level to the upper mark.
6. Install the dipstick and cap onto the filler neck.
27
St @ 40° C 44 to 50
St @ 100° C 7.9 to 8.5
140 to 160
-34° F to -49° F
Vickers I-286-S (Quality
Level), Vickers M-2950-S
(Quality Level), Denison
(Figure 14). Remove the cap
Figure 14
HF-0
g020442