Table of Contents
Advertisement
Using the Rollover
Protection System (ROPS)
WARNING
To avoid injury or death from rollover: keep
the roll bar in the raised locked position and
use the seat belt.
Ensure that the seat is secured with the seat
latch.
WARNING
There is no rollover protection when the roll
bar is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e. branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
Important:
Lower the roll bar only when
absolutely necessary.
1.
To lower the roll bar, remove the hairpin cotters
and the two pins
Figure 55
1. Pin (2)
2.
Lower the roll bar to the down position.
(Figure
55).
2. Hair pin cotter (2)
3.
Install the two pins and secure them with the
hairpin cotter pins.
Important:
with the seat latch.
4.
To raise the roll bar, remove the hairpin cotter
pins and remove the two pins.
5.
Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins
Important:
Always use the seat belt when the
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
Pushing or Towing the
Machine
In an emergency, the machine can be moved
forward by actuating the bypass valve in the variable
displacement hydraulic pump and pushing or towing
the machine.
Important:
Do not push or tow the machine
faster than 3-4.8 km/h (2-3 MPH) because internal
transmission damage may occur. The bypass
valves must be open whenever the machine is
pushed or towed.
1.
Raise the seat. The bypass valves are located
below the front of the fuel tank
2.
Rotate each valve 3 turns counter-clockwise
to open and allow oil to bypass internally. Do
not open more than 3 turns. Because fluid is
bypassed, the machine can be slowly moved
without damaging the transmission.
3.
Close the bypass valves before starting the
engine. Torque to 70 N-m (52 ft-lb) to close the
valve.
g020449
45
Ensure that the seat is secured
(Figure
56).
Advertisement
Table of Contents
