Toro 30607A Operator's Manual page 30

installed) and the remaining spacers onto the
spindle shaft. Install the tensioning cap to
secure the assembly.
5. Remove the hairpin cotter and clevis pin
securing the height-of-cut chains to the rear of
the cutting unit (Figure
Figure 20
1. Height-of-cut chain
6. Mount the height-of-cut chains to the desired
height-of-cut hole
and hairpin cotter.
Figure 21
Note:
When using 25 mm (1 inch), 38 mm
(1-1/2 inch), or occasionally 51 mm (2 inch)
height-of-cut, move the skids and gage wheels
to the highest position.
20).
2. Clevis pin and hair pin
cotter
(Figure 21) with the clevis pin
Side Cutting Units
To adjust the height-of-cut on the side cutting units,
add or remove an equal number of spacers from the
castor forks, position the castor wheel axles in the
high or low height-of-cut holes in the castor forks, and
secure the pivot arms to the selected height-of-cut
bracket holes.
1. Position the castor wheel axles in the same
holes in all of the castor forks
Figure
determine the correct hole for the setting.
2. Remove the tensioning cap from the spindle
shaft
castor arm. Put the two shims (3 mm [1/8
inch]) onto spindle shaft as they were originally
installed. These shims are required to achieve
a level across the entire width of the cutting
units. Slide the appropriate number of 13 mm
(1/2 inch) spacers onto the spindle shaft to get
g011596
the desired height-of-cut; then slide the washer
onto the shaft.
decal100-5624nc
1. Tensioning cap
2. Spacers
3. Shims
Refer to the following chart to determine the
combinations of spacers for the setting.
30
24). Refer to the following chart to
(Figure 22) and slide the spindle out of
Figure 22
4. To axle mounting hole
5. Castor wheel
(Figure 22 and
g008866