Canon iPF9000S Troubleshooting Manual page 71

Code Panel display
(last 4
Large LCD
digits)
4034 ERROR
E196-4034
Call for service.
4037 ERROR
E173-4037
Call for service.
403E ERROR
E161-403E
Call for service.
403F ERROR
E161-403F
Call for service.
4040 ERROR
E196-4040
Call for service.
4041 ERROR
E196-4041
Call for service.
4042 ERROR
E196-4042
Call for service.
4042 Unknown file.
Check file format.
Turn off printer,
wait a while, then
turn it on again.
4043 ERROR
E196-4043
Call for service.
Explanation/Detection sequence
Small LCD
ERROR Multisensor unit version error
E196-4034 A different version of multisensor is
Call For Service installed.
This would not occur in an ordinary
user environment.
ERROR Linear scale error
E173-4037 No signal is available from the carriage
Call For Service encoder when the head is driven.
ERROR Head abnormal temperature rise (head
E161-403E 1 (R), or A model)
Call For Service Either of the two Di sensors
maintained for each printhead chip
(color-specific) has been detected at
o
120
ERROR Head abnormal temperature rise (head
E161-403F 2 (L))
Call For Service Either of the two Di sensors
maintained for each printhead chip
(color-specific) has been detected at
o
120
ERROR Checksum error
E196-4040 The checksum of a file transmitted on
Call For Service execution of the firmware update is
unmatched.
ERROR Flash erase error
E196-4041 Failed to erase flash ROM on
Call For Service execution of the firmware update.
ERROR Flash write error
E196-4042 Failed to write flash ROM on execution
Call For Service of the firmware update.
MIT data transfer failure
Failed to write MIT data on its
transmission.
ERROR Firmware update failure error
E196-4043 Failed to allocate a work area on RAM
Call For Service on firmware update.
2-59
o
C or higher or -10 C or lower.
o
C or higher or -10 C or lower.
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure or tool)
①Replace the
multisensor unit.
Go to ★2F26 (P3-4).
Go to ★403E(P3-21).
Go to ★403E(P3-21).
①Start in download
mode to upgrade
the firmware.
②Restart the printer in
service mode to
clear the error.
③Replace the main
PCB.
①Start in download
mode to upgrade
the firmware.
②Restart the printer in
service mode to
clear the error.
③Replace the main
PCB.
①Start in download
mode to upgrade
the firmware.
②Restart the printer in
service mode to
clear the error.
③Replace the main
PCB.
①Execute "Initialize
Paper Type" from
the system settings.
(Note: All paper
information will be
reset to its factory
defaults and
additional Paper
deleted.)
②Upgrade the
firmware in
download mode.
③Replace the main
PCB.
①Start in download
mode to upgrade
the firmware.
②Restart the printer in
service mode to
clear the error.
③Replace the main
PCB.