Canon iPF9000S Troubleshooting Manual page 29

Panel display
Code
(last 4
Large LCD
digits)
2018 Paper size not
detected.
Lift the release
lever and reload
the paper.
Paper size not
detected.
Reload paper.
Paper size not
detected.
Press Load/Eject
and reload the
paper.
Paper size not
detected.
Lift release lever.
Could not detect
paper size. Push
release lever back,
then pull out the
cut sheet.
Could not detect
paper size.
Press OK, then
insert roll paper
straight into feed
slot.
2019 Cannot cut paper.
Lift the release
lever and reload
the paper.
Cannot cut paper.
Reload the paper.
Paper cutting
failed. Lift the
release lever.
Paper cutting
failed. Remove the
paper
after cutting at the
top of feed slot. Push
the release
lever back.
Small LCD
Papr Size Paper (left) side detection error
Undetected The non-reference edge of paper has been
Press Online Key located by coarse detection but not by a
and Reload second round of fine detection.
Paper
Please Reload
Size Undetected
Press ↑ Key
Cutting failure/jam detected due to a cutting
failure
An idle cutter unit or a cutter blade that is too
blunt to cut sheet has been detected by the
paper leading edge detection sequence. Or,
cutter unit home position detection was
failed.
Explanation/Detection sequence
2-17
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Go to ★2010
(P3-12)
Go to ★2015
(P3-17).
Go to ★2F24
(P3-18).