Canon iPF9000S Troubleshooting Manual page 35

Panel display
Code
(last 4
Large LCD
digits)
2590 Ink insufficient.
to Press OK and
259C replace ink tank.
(*1) Ink insufficient.
Replace ink tank.
259C Ink insufficient.
(*2) Press OK and
to replace ink tank.
25A8
Ink insufficient.
Press OK and
replace ink tank.
25B7 Close the ink tank
cover. Unable to
detect ink level
correctly.
Unable to detect ink
level correctly.
Small LCD
Not Enough Ink
↓
Replace ink tank
orOnline to prnt
Reference)
About 5 mL to 40 mL of ink may have been left in the tank when
this warning occurs.
90:Bk, 91:Y, 92:M, 93:C, 94:PM, 95:PC, 96:MBk1, 97:MBk2,
98:GY, 99:PGY, 9A:R, 9B:B, 9C:G
*1)259C: 03810208-259C
Ink insufficientPress Ink insufficient in inktank.
↓key.
The amount of ink left in the inktank is
Replace inktank or start
printing online.
Reference)
There are the cases that
inktank at warning occurs.
9C:Bk、9D:C、9E:M、9F:Y、A0:PC、A1:PM、A2:MBk1、A3:MBk2、
A4:GY、A5:PGY、A6:R、A7:G、A8:B
*2)259C: 03810104-259C
The remaining ink falls below the pin check
level while ink tank cover is open.
Explanation/Detection sequence
Ink tank short on ink
A print operation was attempted, but there is
not enough ink left in the tank for the
operation.
(In the small LCD, the arrow ↓ points to the
color in question.)
insufficient for printing. (In the small LCD,
the arrow ↓ points to the correspondence
color.)
2-23
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Replace the ink.
②Failure of
remaining ink
detection
system.
(Replace the
supply unit
/check the
bundled wires.)
①Replace inktank
②Failure of
detecting the ink
amount left in the
inktank.
supply unit
(confirm
replacement/harne
ss)
about 5ml to 40ml ink is left
Close the ink tank
cover.
Note) It does not
recover if the
cover is open
when replacing the
ink tank with a
valid one.
If removing the ink
tank with lower ink
remains (LIR) than
Supply Pin in this
situation, an error
is detected.
Also when keeping
printing in this
situation, if empty
subtank
corresponding to
the ink tank with
LIR is detected,
the error shifts
from ink tank with
LIR to empty
subtank.
in a