Canon iPF9000S Troubleshooting Manual page 110

19. Imaging Failures ⑤
misregistration
C1 Software and applications
Printer driver
HDI driver
C2
RIP
Plug-In
C3 Main unit
C4 Color management
Cause
Check to see if any error has been detected by running Nozzle Check Print in
C3
User mode.
C1, C2 AutoCAD
C1, C2, Check to see if any error has been detected by running Nozzle Check Print in
C3, C4 User mode.
Tinting failures
Flow 1
Check with other applications
Application
problems
Application settings
Driver settings
Paper
Paper chromogenicity
problems
Color varied before and after fixing
Driver and MCT version
Paper lot variations
Main unit Firmware version
problems
Color calibration
Maladjusted registration
Driver and MCT version
Head problems Individual head differences
Aging head
Color calibration
Maladjusted registration
Chapter 3 More Sophisticated Fault Isolation Tasks
Defective toning and color
Point to check
Print in PDF
T08 Driver Function Description
Cases (back print, backlight film, plain paper, tracing paper), gamut problems
Paper-specific problems and cases (know-how), evaluation problems/isolation
With proofs, allow pigments to stand for 5 to 10 minutes and dyes to
stand for one day as a rule.
Humidity detection bug; upgraded to V1.35 or later release (if occurring
with Mark II only)
Switch off and check and then rerun with RC base paper.
Perform automatic head adjustment
T15
Upgrades may result in
varied hues
Perform printer calibration
Switch off and check and then rerun with RC base paper.
T15
Perform automatic head adjustment
3-34
Action
2F2F (P3-6）
Imaging Failures ⑥
(P3-37)
Flow 1