Canon iPF9000S Troubleshooting Manual page 23

Panel display
Code
(last 4
Large LCD
digits)
1056 Move the blue
to platen switch No.XX
1062 to the right.
1100 Prepare for
maint cart
replacement.
1101 Replace part soon.
1400 No ink left.
to Press OK and
140C replace ink tank.
Ink tank is empty.
Replace the ink
tank.
Small LCD
The multisensor detected that the platen
shutter used for pre-ejection was closed.
Detection timing:
・At paper loading
・At start of first printing (after upper cover is
opened and closed, or recovery from sleep
mode, or the power is turned on with paper
loaded)
The following list shows the last 2 digits of error codes and the
corresponding messages.
56：No.2, 57：No.3, 58：No.459：No.5, 5A：No.6, 5B：No.75C：No.8,
5D：No.9, 5E：No.105F：No.11, 60：No.12, 61：No.1362：No.14
MTCart Full Soon Maintenance cartridge near-full (continued
usage allowed)
Near-full has been detected from the dot
count and the usage period (drying time).
<Maintenance cartridge detection timings>
The presence of a maintenance cartridge is detected at the
following timings:
①Before printing/during printing (twice per second)/at the end of
②Before a recovery operation/during a recovery operation (twice
③ When the cartridge is removed and inserted following the
Mist Full Soon Mist count near-full
Waste ink near-full has been detected from
the dot count.
Ink tank empty (continued use allowed)
The ink tank has run out of ink, but a certain
volume of ink is reserved in the subtank.
(The reserved volume of ink is put to use
after the remaining ink falls below the pin
check level.)
Displayed only on models having a subtank.
(XX： Display applicable colors)
Last 2 digits: 00:Bk, 01:Y, 02:M, 03:C, 04:PM,
05:PC, 06:MBk1, 07:MBk2, 08:GY, 09:PGY,
0A:R, 0B:B, 0C:G
Explanation/Detection sequence
printing/ between pages
per second)/before opening of the ink supply valve
occurrence of an error or warning.
2-11
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Move the platen
shutter relevant to
the message to
the right, to open
it.
Prepare a
maintenance
cartridge.
Check the parts
counter and
replace the target
unit or Refresh
Service Kit.
Initialize the parts
counter for the
target unit after
the replacement.
①Replace the
tank.
②Failure of
remaining ink
detection
system.
(Replace the
supply unit
/check the
bundled wires.)