Canon iPF9000S Troubleshooting Manual page 26

Panel display
Code
(last 4
Large LCD
digits)
200F This paper
cannot be used.
Check supported
paper sizes.
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject: Change
Paper
2010 Paper loaded askew.
Press Load/Eject
and reload the
paper.
Paper loaded askew.
Reload the paper.
Paper loaded askew.
Lift the
release lever.
Paper loaded askew.
Lift the release
lever and reload
the paper.
Paper loaded askew.
Press OK and
reload the paper.
Paper loaded askew
Lift the release lever.
Small LCD
Paper Size Paper mismatch (size)
Please Check
・The width and length of paper detected are
Paper Too Large
Press ↑ Key
・Cannot detect the leading edge of paper
Paper Too Large
Please Check
Press Online Key
and Reload
・Cannot detect the width of paper even when
the paper is fed by the size mentioned above.
Paper Askew Skew (skewed right)
Please Reload
Paper Skew Paper is determined skewed as its edge is
Press ↑ Key
read by the multisensor.
Paper Loaded
Crooked
Press Online Key
and Reload
Paper loaded
askew.
Remove paper
Explanation/Detection sequence
Paper is too large
longer than the supported size (1.5%
margin).
even when the paper has been fed by 1300
mm for roll paper and by the size
mentioned above for cut sheet.
2-14
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Check paper
conditions
(soiling,
tear-offs,
residual paper
chips, residual
trimming cuts,
folds)/size.
②Has the paper
been fed
successfully
(without
slippage under
a load or any
influence)?
③Has the LF
adjustment
value set
correctly?
④Hasn't the
loaded paper
shrunk to
below its
margin in the
particular
environment?
Go to ★2010
(P3-12).
Reload the
paper.
Go to ★2010
(P3-12).